Yamaha A5000 Owner's Manual - Page 242
Connect the hard disk SCSI cable 50-pin to the connector on the A5000/A4000 circuit
View all Yamaha A5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 242 highlights
Installing Optional Equipment 8. Connect the hard disk SCSI cable (50-pin) to the connector on the A5000/A4000 circuit board. • Connect the flat cable from the hard disk (the flat, thin cable) to the corresponding connector on the sam- pler's main circuit board (marked "C" in the illustration below, "SCSI CN9" on the circuit board itself). The connector is "keyed" so that it will only go in one way. C 9. Connect the hard disk power cable (long) to one of the power connectors in the A5000/ A4000. • Connect the hard disk power cable to any of the available power connectors- CN1, CN2, or CN4. • If no expansion board or ZIP drive is installed, all three connectors will be available. Any of these con- nectors can be used. • If at any time you need to disconnect any of these connectors, do so while pressing the release clip on the plug. Do not apply excessive force. 242 Appendix • A5000/A4000 q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q