Yamaha A5000 Owner's Manual - Page 214
REGISTER, Knob 1, Operation]
View all Yamaha A5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 214 highlights
About the COMMANDS Cursor w (when the FreezeType is SampleBank&LpMode → Samples, SampleBank → Samples, and LpMode → Samples) Cursor w Turn action Press action Knob 1 Cursor EXEC Knob 2 - - Knob 3 From SampleBank - Knob 4 Loop Mode Knob 5 - - EXEC&CONT Knob 1 Same function as Cursor q (page 213). Knob 3 [ Turn] From SampleBank Selects the source Sample Bank for the freeze operation. All Sample Banks in memory can be selected. Knob 4 [ Turn] Loop Mode Sets the Loop Mode. When the Freeze command is executed the Loop Mode settings of all samples within the target Sample Bank are set accordingly. All Loop Modes can be selected (page 123). • This parameter can only be used when the Freeze Type is set to SampleBank&LpMode→Samples or LpMode→Samples. Knob 5 Same function as Cursor q (page 213). REGISTER [COMMAND/EXIT] Button → Knob 1 to highlioght display line 2 → Press Knob 3. This command registers the initial EFFECT, SETUP, and CONTROL function settings which will be recalled whenever the power is turned on or when a program is initialized (page 217) from the specified source program. It also registers the initial sample parameters which will be recalled whenever a sample is recorded (page 151) or imported (page 175) from the specified source sample. • If, for example, you want reverb to be ON whenever the power is turned on or a program is initialized, use the following procedure: 1. Create a program that uses reverb. 2. Go to the REGISTER page and select Program as the Regist Type. 3. Select the program created in step 1 as the Source Program, and set the Regist Source EFFECT parameter to SourcePgm. 4. Execute the Register command. • The registered settings are retained even when the power is turned off. • When new settings are registered the previously registered settings are erased and overwritten. [Operation] 1. Select the Regist Type (page 215). 2. Make other settings as required. 3. Press Knob 1 (EXEC) or Knob 5 (EXEC&CONT), and the register confirmation display will appear. Press Knob 5 (YES) to execute the register operation. • If Knob 1 (EXEC) is used to execute the command, the display previous to the command menu will be recalled after execution has finished. If Knob 5 (EXEC&CONT) is used to execute the command, the register display will be retained so you can continue and perform further register operations. Cursor q Cursor q Turn action Press action Knob 1 Cursor EXEC Knob 2 Regist Type - Knob 3 - - Knob 4 - - Knob 5 - EXEC&CONT Knob 1 [ Turn] Cursor Positions the cursor. [ Press] EXEC Press this knob to call the register confirmation display. Press Knob 5 (YES) to actually execute the register operation. 214 Chapter 9 COMMAND • A5000/A4000 q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q