Yamaha A5000 Owner's Manual - Page 239
Secure the red/white cables and the wide flat cable to the bundle tie., Plug in the power cord.
View all Yamaha A5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 239 highlights
Installing Optional Equipment 7. In the same way, connect the other red-and-white cable (4-wire) to the CN1, CN2, or CN4 connector shown in the illustration. • If no internal hard disk or ZIP drive is installed, all three connectors will be available. Any of these con- nectors can be used. • If at any time you need to disconnect any of these connectors, do so while pressing the release clip on the plug. Do not apply excessive force. The expansion board is now fully installed. There is no need to remove the expansion board when installing other devices. 8. Secure the red/white cables and the wide flat cable to the bundle tie. • Run the flat cable, the 3-wire cable, and the 4-wire cable through the bundle tie (see illustration below). Adjust the tie so that the cables are secure. 9. Replace the top cover (page 233). 10. Plug in the power cord. 239 q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q A5000/A4000 • Appendix