Brother International DCP1000 Service Manual - Page 117
These, messages, appear, alternately.
UPC - 012502565796
View all Brother International DCP1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
Messages on the LCD MACHINE ERROR XX Unplug machine, then call Brother. PAPER JAM Open cover, then remove jammed paper. (These messages appear alternately.) PLS OPEN COVER SCANNER ERROR TONER EMPTY Open cover, then replace new toner cartridge. TONER LOW WARMING UP WAIT FOR A WHILE Probable Cause • "XX" indicates an error code. Refer to [ 2 ] on the following pages. • Paper jam (1) The registration sensor detects no paper within the specified time length after the start of paper pulling-in. (2) The registration sensor has been ON for less than the specified time length (paper of approx. 3.15" long) or for more than the specified time length (paper of approx. 16" long). (3) When the equipment is switched on or the scanner unit is opened and then closed, the registration sensor or paper ejection sensor is ON. (4) The paper ejection sensor sticks to ON. (5) The paper ejection sensor does not come ON within the specified time length after the registration sensor has come ON. (6) The paper ejection sensor is kept ON after the specified time length although the registration sensor has come ON. To display the relating detailed error code, use maintenancemode function code 82. (Refer to Chapter 5, Subsection 5.3.14.) If this message appears, open and close the scanner unit. The message may disappear if opening/closing the scanner unit removes the error. If the error persists, the "MACHINE ERROR XX" will appear. In the scanning compensation data list printed by the maintenance-mode function code 05, fifty percent or more of the white level data is faulty. (This message may appear only in the maintenance mode.) The toner sensor has detected that there is no toner in the cartridge or that no toner cartridge is loaded. If this message appears, recording is no longer possible. The toner sensor has detected that there is not enough toner. The in-casing temperature is too low. If the temperature reaches the appropriate level, the equipment will be automatically recovered from the error state. If only an alarm beep is heard without any message on the LCD when the equipment is powered up, the ROM or RAM will be defective. 6-3