Brother International DCP1000 Service Manual - Page 68
Remove, screws, fixing, unit., disconnect, brown, heater, wires, harness, thermistor, harness,
UPC - 012502565796
View all Brother International DCP1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
4.1.12 Heat-fixing Unit, FU Lamp, and Paper Ejection Sensor Actuator (1) Remove the two screws from the heat-fixing unit. (2) Lift up the heat-fixing unit and disconnect the blue and brown heater wires (of the heater harness) from the heat-fixing unit. Then disconnect the heater thermistor harness from the EL (eraser lamp) board. (3) Remove the paper ejection sensor actuator from the bottom of the heat-fixing unit. Heat-fixing unit Taptite, cup B M4x 16 Relay (CCD/SEN) harness A Paper ejection sensor actuator c O Grounding wire Relay (CCD/PANEL) harness Brown heater wire 4%- Main cover EL (eraser lamp) board Blue heater wire 4-40
4.1.12
Heat
-fixing
Unit,
FU
Lamp,
and
Paper
Ejection
Sensor
Actuator
(1)
Remove
the
two
screws
from
the
heat
-fixing
unit.
(2)
Lift
up
the
heat
-fixing
unit
and
disconnect
the
blue
and
brown
heater
wires
(of
the
heater
harness)
from
the
heat
-fixing
unit.
Then
disconnect
the
heater
thermistor
harness
from
the
EL
(eraser
lamp)
board.
(3)
Remove
the
paper
ejection
sensor
actuator
from
the
bottom
of
the
heat
-fixing
unit.
Taptite,
cup
B
M4x
16
Heat
-fixing
unit
A
Relay
(CCD/SEN)
harness
O
Grounding
wire
Relay
(CCD/PANEL)
harness
c
4%
-
4-40
Paper
ejection
sensor
actuator
Brown
heater
wire
Main
cover
EL
(eraser
lamp)
board
Blue
heater
wire