Brother International DCP1000 Service Manual - Page 84
Eraser, Board, Reassembling, Notes
UPC - 012502565796
View all Brother International DCP1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
4.1.24 EL (Eraser Lamp) Board Only when you need to replace the EL board (which is attached with double-sided adhesive tape), remove it according to the steps below. (1) Make sure that the EL harness is disconnected from the high-voltage power supply PCB. (Refer to Subsection 4.1.17.) (2) Make sure that the heat-fixing unit is removed. (3) Peel off the EL board from the main cover and clear adhesive tape if remaining. EL (eraser lamp) board Attaching a new EL board Rib 2 C O. Main cover • Reassembling Notes • When attaching a new EL board, bring the right end into contact with the rib provided on the main cover. 4-56
4.1.24
EL
(Eraser
Lamp)
Board
Only
when
you
need
to
replace
the
EL
board
(which
is
attached
with
double
-sided
adhesive
tape),
remove
it
according
to
the
steps
below.
(1)
Make
sure
that
the
EL
harness
is
disconnected
from
the
high
-voltage
power
supply
PCB.
(Refer
to
Subsection
4.1.17.)
(2)
Make
sure
that
the
heat
-fixing
unit
is
removed.
(3)
Peel
off
the
EL
board
from
the
main
cover
and
clear
adhesive
tape
if
remaining.
EL
(eraser
lamp)
board
Attaching
a
new
EL
board
Rib
2
C
O.
Main
cover
•
Reassembling
Notes
•
When
attaching
a
new
EL
board,
bring
the
right
end
into
contact
with
the
rib
provided
on
the
main
cover.
4-56