Brother International DCP1000 Service Manual - Page 76
Remove, screw, voltage, insulator, sheet., Slightly, power, supply, disconnect, cable, eraser,
UPC - 012502565796
View all Brother International DCP1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
4.1.17 High-voltage Power Supply PCB (1) Remove the screw and take off the high-voltage insulator sheet. (2) Slightly lift up the high-voltage power supply PCB and disconnect the high-voltage power flat cable and EL (eraser lamp) harness. Taptite, bind B M4x 12 7 High-voltage insulator sheet High-voltage power supply PCB I High-voltage power flat cable ••• v k EL (eraser lamp) harness 4;' Main cover (placed upside down) ■ Reassembling Notes • Fold the high-voltage power flat cable and route it as illustrated above. • Before reinstalling the high-voltage power supply PCB, check the high-voltage contacts for any toner particles, paper dust or dirt, and clean them out. 4-48
4.1.17
High
-voltage
Power
Supply
PCB
(1)
Remove
the
screw
and
take
off
the
high
-voltage
insulator
sheet.
(2)
Slightly
lift
up
the
high
-voltage
power
supply
PCB
and
disconnect
the
high
-voltage
power
fl
at
cable
and
EL
(eraser
lamp)
harness.
Taptite,
bind
B
M4x
12
7
I
•••
v
k
■
Reassembling
Notes
4;'
High
-voltage
insulator
sheet
High
-voltage
power
supply
PCB
High
-voltage
power
fl
at
cable
EL
(eraser
lamp)
harness
Main
cover
(placed
upside
down)
•
Fold
the
high
-voltage
power
flat
cable
and
route
it
as
illustrated
above.
•
Before
reinstalling
the
high
-voltage
power
supply
PCB,
check
the
high
-voltage
contacts
for
any
toner
particles,
paper
dust
or
dirt,
and
clean
them
out.
4-48