Cisco IE-3000-8TC Command Reference - Page 115

Chapter 2 IE 3000 Switch Cisco IOS Commands dot1x fallback dot1x fallback Use the dot1xfallback interface configuration command on the to configure a port to use web authentication as a fallback method for clients that do not support IEEE 802.1x authentication. To return to the default setting, use the no form of this command. dot1x fallback profile no dot1x fallback Syntax Description profile Specify a fallback profile for clients that do not support IEEE 802.1x authentication. Defaults No fallback is enabled. Command Modes Interface configuration Command History Release 12.2(44)EX Modification This command was introduced. Usage Guidelines You must enter the dot1x port-control auto interface configuration command on a switch port before entering this command. Examples This example shows how to specify a fallback profile to a switch port that has been configured for IEEE 802.1x authentication: Switch# configure terminal Enter configuration commands, one per line. End with CNTL/Z. Switch(config)# interface gigabitethernet1/3 Switch(config-if)# dot1x fallback profile1 Switch(config-fallback-profile)# exit Switch(config)# end You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC command. Related Commands Command show dot1x [interface interface-id] fallback profile ip admission ip admission name proxy http Description Displays IEEE 802.1x status for the specified port. Create a web authentication fallback profile. Enable web authentication on a port Enable web authentication globally on a switch OL-13019-01 Cisco IE 3000 Switch Command Reference 2-89