Cisco IE-3000-8TC Command Reference - Page 203

Chapter 2 IE 3000 Switch Cisco IOS Commands location (interface configuration) location (interface configuration) Use the location interface command to enter location information for an interface. Use the no form of this command to remove the interface location information. location {additional-location-information word | civic-location-id id | elin-location-id id} no location {additional-location-information word | civic-location-id id | elin-location-id id} Syntax Description additional-location-information civic-location-id elin-location-id id word Configure additional information for a location or place. Configure global civic location information for an interface. Configure emergency location information for an interface. Specify the ID for the civic location or the elin location. The ID range is 1 to 4095. Specify a word or phrase that provides additional location information. Defaults This command has no default setting. Command Modes Interface configuration Command History Release 12.2(44)EX Modification This command was introduced. Usage Guidelines After entering the location civic-location-id id interface configuration command, you enter civic location configuration mode. In this mode, you can enter the additional location information. Examples These examples show how to enter civic location information for an interface: Switch(config-if)# int g1/1 Switch(config-if)# location civic-location-id 1 Switch(config-if)# end Switch(config-if)# int g1/1 Switch(config-if)# location civic-location-id 1 Switch(config-if)# end You can verify your settings by entering the show location civic interface privileged EXEC command. This example shows how to enter emergency location information for an interface: Switch(config)# int g1/2 Switch(config-if)# location elin-location-id 1 Switch(config-if)# end OL-13019-01 Cisco IE 3000 Switch Command Reference 2-177