Cisco IE-3000-8TC Command Reference - Page 298

policy-map Chapter 2 IE 3000 Switch Cisco IOS Commands Examples This example shows how to create a policy map called policy1. When attached to the ingress port, it matches all the incoming traffic defined in class1, sets the IP DSCP to 10, and polices the traffic at an average rate of 1 Mb/s and bursts at 20 KB. Traffic exceeding the profile is marked down to a DSCP value gotten from the policed-DSCP map and then sent. Switch(config)# policy-map policy1 Switch(config-pmap)# class class1 Switch(config-pmap-c)# set dscp 10 Switch(config-pmap-c)# police 1000000 20000 exceed-action policed-dscp-transmit Switch(config-pmap-c)# exit This example shows how to configure multiple classes in a policy map called policymap2: Switch(config)# policy-map policymap2 Switch(config-pmap)# class class1 Switch(config-pmap-c)# set dscp 10 Switch(config-pmap-c)# police 1000000 20000 exceed-action policed-dscp-transmit Switch(config-pmap-c)# exit Switch(config-pmap)# class class2 Switch(config-pmap-c)# trust dscp Switch(config-pmap-c)# police 1000000 20000 exceed-action drop Switch(config-pmap-c)# exit Switch(config-pmap)# class class3 Switch(config-pmap-c)# set dscp 0 (no policer) Switch(config-pmap-c)# exit This example shows how to delete policymap2: Switch(config)# no policy-map policymap2 You can verify your settings by entering the show policy-map privileged EXEC command. Related Commands Command class class-map service-policy show policy-map Description Defines a traffic classification match criteria (through the police, set, and trust policy-map class configuration command) for the specified class-map name. Creates a class map to be used for matching packets to the class whose name you specify. Applies a policy map to a port. Displays QoS policy maps. 2-272 Cisco IE 3000 Switch Command Reference OL-13019-01