Cisco IE-3000-8TC Command Reference - Page 143

Chapter 2 IE 3000 Switch Cisco IOS Commands fallback profile fallback profile Use the fallback profile global configuration command to create a fallback profile for web authentication. To return to the default setting, use the no form of this command. fallback profile profile no fallback profile Syntax Description profile Specify the fallback profile for clients that do not support IEEE 802.1x authentication. Defaults No fallback profile is configured. Command Modes Global configuration Command History Release 12.2(44)EX Modification This command was introduced. Usage Guidelines The fallback profile is used to define the IEEE 802.1x fallback behavior for IEEE 802.1x ports that do not have supplicants. The only supported behavior is to fall back to web authentication. After entering the fallback profile command, you enter profile configuration mode, and these configuration commands are available: • ip: Create an IP configuration. • access-group: Specify access control for packets sent by hosts that have not yet been authenticated. • admission: Apply an IP admission rule. Examples This example shows how to create a fallback profile to be used with web authentication: Switch# configure terminal Switch(config)# ip admission name rule1 proxy http Switch(config)# fallback profile profile1 Switch(config-fallback-profile)# ip access-group default-policy in Switch(config-fallback-profile)# ip admission rule1 Switch(config-fallback-profile)# exit Switch(config)# interface gigabitethernet 1/1 Switch(config-if)# dot1x fallback profile1 Switch(config-if)# end You can verify your settings by entering the show running-configuration [interface interface-id] privileged EXEC command. OL-13019-01 Cisco IE 3000 Switch Command Reference 2-117