Cisco IE-3000-8TC Command Reference - Page 560
spanning-tree port-priority
![]() |
View all Cisco IE-3000-8TC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 560 highlights
spanning-tree port-priority Chapter 2 IE 3000 Switch Cisco IOS Commands spanning-tree port-priority Use the spanning-tree port-priority interface configuration command to configure an interface priority. If a loop occurs, spanning tree can find the interface to put in the forwarding state. Use the no form of this command to return to the default setting. spanning-tree [vlan vlan-id] port-priority priority no spanning-tree [vlan vlan-id] port-priority Syntax Description vlan vlan-id priority (Optional) VLAN range associated with a spanning-tree instance. You can specify a single VLAN identified by VLAN ID number, a range of VLANs separated by a hyphen, or a series of VLANs separated by a comma. The range is 1 to 4094. Number from 0 to 240, in increments of 16. Valid values are 0, 16, 32, 48, 64, 80, 96, 112, 128, 144, 160, 176, 192, 208, 224, and 240. All other values are rejected. The lower the number, the higher the priority. Defaults The default is 128. Command Modes Interface configuration Command History Release 12.2(44)EX Modification This command was introduced. Usage Guidelines If the variable vlan-id is omitted, the command applies to the spanning-tree instance associated with VLAN 1. You can set the priority on a VLAN that has no interfaces assigned to it. The setting takes effect when you assign the interface to the VLAN. If you configure an interface with both the spanning-tree vlan vlan-id port-priority priority command and the spanning-tree port-priority priority command, the spanning-tree vlan vlan-id port-priority priority command takes effect. Examples This example shows how to increase the likelihood that a port will be put in the forwarding state if a loop occurs: Switch(config)# interface gigabitethernet1/2 Switch(config-if)# spanning-tree vlan 20 port-priority 0 This example shows how to set the port-priority value on VLANs 20 to 25: Switch(config-if)# spanning-tree vlan 20-25 port-priority 0 You can verify your settings by entering the show spanning-tree interface interface-id privileged EXEC command. 2-534 Cisco IE 3000 Switch Command Reference OL-13019-01
![](/manual_guide/products/cisco-ie30008tc-command-reference-94363f4/560.png)