Cisco IE-3000-8TC Command Reference - Page 21

1 C H A P T E R Using the Command-Line Interface The IE 3000 switch is supported by Cisco IOS software. This chapter describes how to use the switch command-line interface (CLI) to configure software features. • For a complete description of the commands that support these features, see Chapter 2, "IE 3000 Switch Cisco IOS Commands." • For information on the bootloader commands, see Appendix A, "IE 3000 Switch Bootloader Commands." • For information on the debug commands, see Appendix B, "IE 3000 Switch Debug Commands." • For information on the show platform commands, see Appendix C, "IE 3000 Switch Show Platform Commands." • For more information on Cisco IOS Release 12.2, see the Cisco IOS Release 12.2 Command Summary. • For task-oriented configuration steps, see the software configuration guide for this release. In this document, IP refers to IP version 4 (IPv4). CLI Command Modes This section describes the CLI command mode structure. Command modes support specific Cisco IOS commands. For example, the interface interface-id command only works when entered in global configuration mode. These are the main command modes for the switch: • User EXEC • Privileged EXEC • Global configuration • Interface configuration • Config-vlan • VLAN configuration • Line configuration OL-13019-01 Cisco IE 3000 Switch Command Reference 1-1