Cisco IE-3000-8TC Command Reference - Page 425

Chapter 2 IE 3000 Switch Cisco IOS Commands show lacp Table 2-27 show lacp counters Field Descriptions Field LACPDUs Sent and Recv Marker Sent and Recv Marker Response Sent and Recv LACPDUs Pkts and Err Description The number of LACP packets sent and received by a port. The number of LACP marker packets sent and received by a port. The number of LACP marker response packets sent and received by a port. The number of unknown and illegal packets received by LACP for a port. This is an example of output from the show lacp internal command: Switch> show lacp 1 internal Flags: S - Device is requesting Slow LACPDUs F - Device is requesting Fast LACPDUs A - Device is in Active mode P - Device is in Passive mode Channel group 1 Port Gi1/1 Gi1/2 Flags SA SA State bndl bndl LACP port Priority 32768 32768 Table 2-28 describes the fields in the display: Admin Key 0x3 0x3 Oper Key 0x3 0x3 Port Number 0x4 0x5 Port State 0x3D 0x3D Table 2-28 show lacp internal Field Descriptions Field State LACP Port Priority Description State of the specific port. These are the allowed values: • - -Port is in an unknown state. • bndl-Port is attached to an aggregator and bundled with other ports. • susp-Port is in a suspended state; it is not attached to any aggregator. • hot-sby-Port is in a hot-standby state. • indiv-Port is incapable of bundling with any other port. • indep-Port is in an independent state (not bundled but able to switch data traffic. In this case, LACP is not running on the partner port). • down-Port is down. Port priority setting. LACP uses the port priority to put ports s in standby mode when there is a hardware limitation that prevents all compatible ports from aggregating. OL-13019-01 Cisco IE 3000 Switch Command Reference 2-399