Cisco IE-3000-8TC Command Reference - Page 637

Chapter 2 IE 3000 Switch Cisco IOS Commands vlan database vlan database Use the vlan database privileged EXEC command to enter VLAN configuration mode. From this mode, you can add, delete, and modify VLAN configurations for normal-range VLANs and globally propagate these changes by using the VLAN Trunking Protocol (VTP). Configuration information is saved in the VLAN database. vlan database Note VLAN configuration mode is only valid for VLAN IDs 1 to 1005. Syntax Description This command has no arguments or keywords. Defaults No default is defined. Command Modes Privileged EXEC Command History Release 12.2(44)EX Modification This command was introduced. Usage Guidelines You can use the VLAN database configuration commands to configure VLANs 1 to 1005. To configure extended-range VLANs (VLAN IDs 1006 to 4094), use the vlan (global configuration) command to enter config-vlan mode. You can also configure VLAN IDs 1 to 1005 by using the vlan global configuration command. To return to the privileged EXEC mode from the VLAN configuration mode, enter the exit command. Note This command mode is different from other modes because it is session-oriented. When you add, delete, or modify VLAN parameters, the changes are not applied until you exit the session by entering the apply or exit command. When the changes are applied, the VTP configuration version is incremented. You can also not apply the changes to the VTP database by entering abort. When you are in VLAN configuration mode, you can access the VLAN database and make changes by using these commands: • vlan: accesses subcommands to add, delete, or modify values associated with a single VLAN. For more information, see the vlan (VLAN configuration) command. • vtp: accesses subcommands to perform VTP administrative functions. For more information, see the vtp (VLAN configuration) command. OL-13019-01 Cisco IE 3000 Switch Command Reference 2-611