Dell PowerEdge C6300 Dell PowerEdge C6320 Owners Manual - Page 125
Installing the sensor board for 2.5 inch hard-drive system
View all Dell PowerEdge C6300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Installing the sensor board for 2.5 inch hard-drive system CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1. Replace the sensor board into the sensor-board holder. 2. Replace the sensor board assembly into the hard drive cage. 3. Replace the screw that secures the sensor board to the hard drive cage. 4. Connect the sensor board cable to the sensor board. 5. Replace the hard drive cage into the chassis. 6. Replace the screws that secure the hard-drive cage to the chassis. 7. Connect all the cables to the backplane. NOTE: You must route these cables properly on the chassis to prevent them from being pinched or crimped. 8. Connect the front panel cables to the power distribution board. NOTE: You must route these cables properly on the chassis to prevent them from being pinched or crimped. 9. Close the system. 10. Replace the hard drives. 11. Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals. Related Information Closing the system Installing a hard drive into a hard-drive carrier Cable routing for sensor board and front panel for 2.5 inch hard drive system 1. Connect the Y-shaped cable for the sensor board and front panel 2 to the connector on the power distribution board 1, and connect the other two ends of the cable to the connectors on the sensor board and the front panel 2 respectively. 2. Connect the front panel cable to the connector on the power distribution board 1, and connect the other end of the cable to the connector on the front panel 1. 125