HP Photosmart C7100 Basics Guide - Page 61

Load an original in the Slide and Negative Film holder - scan to computer

Page 61 highlights

Chapter 4 To load 10 x 15 cm (4 x 6 inch) photo paper in the photo tray 1. Raise the output tray until it goes no further. 2. Pull out the photo tray. 3. Insert the stack of photo paper into the photo tray with the short edge forward and the glossy side down. Slide the stack of photo paper forward until it stops. If the photo paper you are using has perforated tabs, load the photo paper so that the tabs are closest to you. 4. Slide the paper-length and paper-width guides inward against the stack of photo paper until the guides stop. Do not overload the photo tray; make sure the stack of photo paper fits within the photo tray and is no higher than the top of the paper-width guide. 5. Push in the photo tray, and then lower the output tray. Load an original in the Slide and Negative Film holder You can scan 35 mm slides and negatives with the HP All-in-One using the Slide and Negative Film holder. Use the HP All-in-One features 58 HP Photosmart C7100 All-in-One series

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116

To load 10 x 15 cm (4 x 6 inch) photo paper in the photo tray
1.
Raise the output tray until it goes no further.
2.
Pull out the photo tray.
3.
Insert the stack of photo paper into the photo tray with the short edge forward and
the glossy side down. Slide the stack of photo paper forward until it stops.
If the photo paper you are using has perforated tabs, load the photo paper so that
the tabs are closest to you.
4.
Slide the paper-length and paper-width guides inward against the stack of photo
paper until the guides stop.
Do not overload the photo tray; make sure the stack of photo paper fits within the
photo tray and is no higher than the top of the paper-width guide.
5.
Push in the photo tray, and then lower the output tray.
Load an original in the Slide and Negative Film holder
You can scan 35 mm slides and negatives with the HP All-in-One using the Slide and
Negative Film holder.
Chapter 4
58
HP Photosmart C7100 All-in-One series
Use the HP All-in-One features