HP Photosmart C7100 Basics Guide - Page 91

Solution, Cause, HP Photosmart C7100 All-in-One series

Get HP Photosmart C7100 - All-in-One Printer PDF manuals and user guides View all HP Photosmart C7100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 91 highlights

Troubleshooting and support Chapter 5 Solution If you have a computer dial-up modem on the same phone line as the HP All-inOne, check to make sure that the software that came with your modem is not set to receive faxes automatically. Modems that are set up to receive faxes automatically take over the phone line to receive all incoming faxes, which prevents the HP All-in-One from receiving fax calls. Cause If you have an answering machine on the same phone line with the HP All-in-One, you might have one of the following problems: ● Your outgoing message might be too long or too loud to allow the HP All-in-One to detect fax tones, and the sending fax machine might disconnect. ● Your answering machine might not have enough quiet time after your outgoing message to allow the HP All-in-One to detect fax tones. This problem is most common with digital answering machines. Solution If you have an answering machine on the same phone line with the HP All-in-One, do the following: ● Disconnect the answering machine and then try receiving a fax. If faxing is successful without the answering machine, the answering machine might be causing the problem. ● Reconnect the answering machine and record your outgoing message again. Record a message that is approximately 10 seconds in duration. Speak slowly and at a low volume when recording your message. Leave at least 5 seconds of silence at the end of the voice message. There should be no background noise when recording this silent time. Try to receive a fax again. Cause The answering machine is not set up properly with the HP All-in-One. Solution Note This possible solution applies only in the countries/regions that receive a 2-wire phone cord in the box with the HP All-in-One, including: Argentina, Australia, Brazil, Canada, Chile, China, Colombia, Greece, India, Indonesia, Ireland, Japan, Korea, Latin America, Malaysia, Mexico, Philippines, Poland, Portugal, Russia, Saudi Arabia, Singapore, Spain, Taiwan, Thailand, USA, Venezuela, and Vietnam. When you have an answering machine on the same phone line you use for fax calls, you must connect the answering machine directly to the HP All-in-One using the port labeled 2-EXT, as shown below. You also need to set the correct number of rings to answer for both the answering machine and HP All-in-One. 1 Telephone wall jack 2 Connect to the IN port on the answering machine 3 Connect to the OUT port on the answering machine 88 HP Photosmart C7100 All-in-One series

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
Solution
If you have a computer dial-up modem on the same phone line as the HP All-in-
One, check to make sure that the software that came with your modem is not set to receive
faxes automatically. Modems that are set up to receive faxes automatically take over the phone
line to receive all incoming faxes, which prevents the HP All-in-One from receiving fax calls.
Cause
If you have an answering machine on the same phone line with the HP All-in-One,
you might have one of the following problems:
●
Your outgoing message might be too long or too loud to allow the HP All-in-One to detect
fax tones, and the sending fax machine might disconnect.
●
Your answering machine might not have enough quiet time after your outgoing message
to allow the HP All-in-One to detect fax tones. This problem is most common with digital
answering machines.
Solution
If you have an answering machine on the same phone line with the HP All-in-One,
do the following:
●
Disconnect the answering machine and then try receiving a fax. If faxing is successful
without the answering machine, the answering machine might be causing the problem.
●
Reconnect the answering machine and record your outgoing message again. Record a
message that is approximately 10 seconds in duration. Speak slowly and at a low volume
when recording your message. Leave at least 5 seconds of silence at the end of the voice
message. There should be no background noise when recording this silent time. Try to
receive a fax again.
Cause
The answering machine is not set up properly with the HP All-in-One.
Solution
Note
This possible solution applies only in the countries/regions that receive a 2-wire
phone cord in the box with the HP All-in-One, including: Argentina, Australia, Brazil,
Canada, Chile, China, Colombia, Greece, India, Indonesia, Ireland, Japan, Korea,
Latin America, Malaysia, Mexico, Philippines, Poland, Portugal, Russia, Saudi Arabia,
Singapore, Spain, Taiwan, Thailand, USA, Venezuela, and Vietnam.
When you have an answering machine on the same phone line you use for fax calls, you must
connect the answering machine directly to the HP All-in-One using the port labeled 2-EXT, as
shown below. You also need to set the correct number of rings to answer for both the answering
machine and HP All-in-One.
1
Telephone wall jack
2
Connect to the IN port on the answering machine
3
Connect to the OUT port on the answering machine
Chapter 5
88
HP Photosmart C7100 All-in-One series
Troubleshooting and support