Netgear GS728TPP GS728TP/GS728TPP/GS752TP Software Administration Manual - Page 53
Trap Flags, SNMP Supported MIBs, To con the trap flags, System, SNMP v1/v2, APPLY
View all Netgear GS728TPP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches Trap Flags Use the Trap Flags screen to enable or disable traps the switch can send to an SNMP manager. When the condition identified by an active trap encounters the switch, a trap message is sent to any enabled SNMP trap receivers, and a message is written to the trap log. To configure the trap flags: 1. Select System SNMP SNMP v1/v2 Trap Flags. The following screen displays: 2. From the All field, globally enable or disable activation of all traps by selecting the corresponding button. The factory default is Enable. 3. From the Authentication field, enable or disable activation of authentication failure traps by selecting the corresponding button. The factory default is Enable. 4. Click APPLY. Configuration changes take effect immediately. SNMP Supported MIBs The screen allows you to view a list of the supported MIBs. Configuring System Information 53