Netgear GS748Tv4 GS748Tv4 Software Administration Manual - Page 130

GS748T Smart Switch Software Administration Manual 2. To configure CoS queue settings for a Link Aggregation Group (LAG), click LAGS. 3. To configure CoS queue settings for both physical ports and LAGs, click ALL. 4. Select the check box next to the port or LAG to configure. You can select multiple ports and LAGs to apply the same setting to the selected interfaces. Select the check box in the heading row to apply a trust mode or rate to all interfaces. 5. Configure any of the following settings: • Queue ID. Use the menu to select the queue to be configured. • Minimum Bandwidth. Enter a percentage of the maximum negotiated bandwidth for the selected queue on the interface. Specify a percentage from 0-100, in increments of 1. • Scheduler Type. Selects the type of queue processing from the drop down menu. Options are Weighted and Strict. Defining on a per-queue basis allows the user to create the desired service characteristics for different types of traffic. • Weighted: Weighted round robin associates a weight to each queue. This is the default. • Strict: Services traffic with the highest priority on a queue first. • Queue Management Type. Displays the type of packet management used for all packets, which is Taildrop. All packets on a queue are safe until congestion occurs. At this point, any additional packets queued are dropped. 6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch. 7. If you make changes to the page, click Apply to apply the changes to the system. 802.1p to Queue Mapping The 802.1p to Queue Mapping page also displays the Current 802.1p Priority Mapping table. To display the 801.p to Queue Mapping page, click QoS > CoS > Advanced > 802.1p to Queue Mapping. 130 | Chapter 4: Configuring Quality of Service