Netgear GS748Tv4 GS748Tv4 Software Administration Manual - Page 237
Hostname/IP Address, Probes Per Hop, MaxTTL, InitTTL, MaxFail, Interval, Cancel, Apply
View all Netgear GS748Tv4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 237 highlights
GS748T Smart Switch Software Administration Manual 1. In the Hostname/IP Address field, specify the IP address or the hostname of the station you want the switch to ping. The initial value is blank. This information is not retained across a power cycle. 2. Optionally, configure the following settings: • Probes Per Hop. Specify the number of times each hop should be probed. The valid range is 1-10. • MaxTTL. Specify the maximum time-to-live for a packet in number of hops. The valid range is 1-255. • InitTTL. Specify the initial time-to-live for a packet in number of hops. The valid range is 0- 255. • MaxFail. Specify the maximum number of failures allowed in the session. The valid range is 0-255. • Interval. Specify the time between probes in seconds. The valid range is 1-60. • Port. Specify the UDP destination port in probe packets. The valid range is 1-65535. • Size. Specify the size of probe packets. The valid range is 0-65507. 3. Click Cancel to cancel the operation on the screen and reset the data on the screen to the latest value of the switch. 4. Click Apply to initiate the traceroute. The results display in the TraceRoute area. Chapter 7: Maintenance | 237