Netgear GS748Tv4 GS748Tv4 Software Administration Manual - Page 236
Traceroute, Link Local Address, IPv6 Address/Hostname, Datagram Size, Cancel, Apply, Count, Result
View all Netgear GS748Tv4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 236 highlights
GS748T Smart Switch Software Administration Manual • Link Local Address. Enter the link local address of the station you want the switch to ping. The initial value is blank. The Link Local Address you enter is not retained across a power cycle. • IPv6 Address/Hostname. Enter the IPv6 address or Hostname of the station you want the switch to ping. The initial value is blank. The IPv6 Address or Hostname you enter is not retained across a power cycle. • Datagram Size. Enter the datagram size. The valid range is 48-2048. 4. Click Cancel to cancel the operation on the screen and reset the data on the screen to the latest value of the switch. 5. Click Apply to send the ping. The switch sends the number of pings specified in the Count field, and the results are displayed below the configurable data in the Result area. • If successful, the output will be Send count=3, Receive count = n from (IPv6 Address).Average round trip time = n ms. • If a reply to the ping is not received, the following displays: "Reply From IP/Host: Destination Unreachable. Tx = x, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec". Traceroute Use the Traceroute utility to discover the paths that a packet takes to a remote destination. To display this page, click Maintenance > Troubleshooting > Traceroute. To configure the Traceroute settings and send probe packets to discover the route to a host on the network: 236 | Chapter 7: Maintenance