Panasonic WJ-HD716/1000 Installation Guide - Page 153

Specifications • General Power source: Power consumption: Ambient operating temperature: Ambient operating humidity: Maximum operating altitude: Dimensions (excluding rubber feet and projections) Weight: Finish: 120 V AC, 60 Hz 130 W +5 °C to +45 °C {+41 °F to +113 °F} 5 % to 90 % (non condensing) When installing WJ-HDB611: 10 % to 80 % (non condensing) 2 000 m {6 562 feet} or less 430 mm (W) x 132 mm (H) x 400 mm (D) {16-15/16"" (W) x 5-3/16" (H) x 15-3/4" (D)} When no hard disk drive is installed: 14 kg {30.91 lbs.} When 4 hard disk drives are installed: 17 kg {37.53 lbs.} Front cover: Solid metallic coating Top cover: Solid metallic coating Rear panel: Galvanized steel • HDD (Locally procured - Contact your dealer about purchasing hard disk drives.) Hard disk drive: 3.5" hard disk drive (Up to 4 hard disk drives can be installed.) • Input/output Video Video input connector: 1 V [p-p]/75 Ω, x16 (1ch to 16ch) (BNC) Vertical timing pulse multiplexed, HD616K: x8 (1ch to 8ch), HD716K: x16 Cascade input connector: 1 V [p-p]/75 Ω (BNC) HDMI, x2 Video output connector: 1 V [p-p]/75 Ω, active loop-thru output, x16 (1ch to 16ch) (BNC)*1 Monitor output connector: 1 V [p-p]/75 Ω, x2 (BNC) Monitor (HDMI) connector: HDMI, x2*8 Video output connector (front): 1 V [p-p]/75 Ω, x1 (RCA pin) Audio Audio input connector: -10 dBv, 10 kΩ, unbalanced, x4 (RCA pin) Cascade input connector: -10 dBv, 10 kΩ, unbalanced x 1 (RCA pin) Audio output connector: -10 dBv, 600 Ω, unbalanced, x1 (RCA pin) Audio output connector (front): -10 dBv, 600 Ω, unbalanced, x1 (RCA pin) Others External storage connector: x3 Mouse connection port: x1 Alarm/control terminal: 8 to 16ch alarm output*3, alarm reset input*2, emergency recording input*2, available space warning output*3, HDD trouble output*3, camera trouble output*3, trouble out- put*3, electricity failure recovery completion output*4, time adjust input/output*5, sequence switching input/output*5, alarm suspension input*2, electricity failure detec- tion input*2, external recording mode switching*2, +5 V output*6 (25-pin D-sub) Alarm terminal: 1ch - 16ch alarm input*2, 1 - 7ch alarm output*3 (25-pin D-sub) RS485 port: RS485 (full duplex/half duplex*7), x2 (RJ-11) DATA port: RS485, x2 (RJ-11) Network port: 10BASE-T/100BASE-TX (RJ-45) Maintenance port: 10BASE-T (RJ-45) SDHC/SD memory card slot: SDHC/SD memory cards applicable (miniSD cards and microSD cards not applica- ble) *1 When power is not supplied, the video output signal was not sent from the recorder even if a video input signal is supplied. *2 Non-voltage make contact input, 50 kΩ +5 V DC pull-up 153