Panasonic WJ-HD716/1000 Installation Guide - Page 92
Con the settings relating to communication with other devices
View all Panasonic WJ-HD716/1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
Configure the settings relating to communication with other devices [Communication] It is necessary to apply the same settings such as the communication speed and the communication protocol to the recorder and the external devices such as a controller connected to the DATA port on the rear panel of the recorder The settings relating to the communication method to control cameras and to communicate with external devices can be configured on the "Communication" page. The "Communication" page has [Camera control], [PS·Data setup] and [RS485 setup] tabs. Configure the communication settings for camera control [Camera control] Select the [Camera control] tab on the "Communication" page. (☞ Page 60) The communication settings for each camera channel to control cameras can be configured on this tab. [Comp] It is possible to compensate for the video signal transmission loss from the camera. For HD616K, the setting is available for Camera 1 to 8. For HD716K, the setting is available for Camera 1 to 16. Select the setting value in accordance with the cable length. For HD616K, the setting is available for Camera 1 to 8. For HD716K, the setting is available for Camera 1 to 16. S: When the length of cable used is shorter than 500 m {2 953 ft} M: When the length of cable used is longer than 500 m {1 640 ft} and shorter than 900 m {2 953 ft} L: When the length of cable used is longer than 900 m {2 953 ft} and shorter than 1 200 m {3 937 ft} Default: S [Type] Configure the communication settings for each camera channel to control cameras. COAX: Controls cameras with coaxial communication. For HD616K, the setting is available for Camera 1 to 8. For HD716K, the setting is available for Camera 1 to 16. PSD: Controls cameras with PS·Data communication. RS485: Controls cameras with RS485 communication. Off: Not controls cameras. Default: Camera 1 to 18: COAX, Camera 9 to 16: PS·Data (COAX for HD716K) : 92 Note: • Configure the settings in accordance with cameras con- nected to the reorder. • To control cameras with the coaxial cable, connect cam- eras to the video input connectors 1 to 8 (compatible with coaxial cable communication). Use a Panasonic data multiplex unit to control cameras connected to other camera channels with coaxial cables. In this case, select "PSD" for the communication method of the camera to be controlled via the data multiplex unit. • For HD716K, it is possible to control cameras connected to the video input connectors 1 to 16 with the coaxial communication. • Set the unused camera channels to "Off".