Brother International Quattro 2 6700D Users Manual - English - Page 102
Flat Fell Seam
View all Brother International Quattro 2 6700D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
SEWING THE STITCHES c Pull the bobbin and upper threads out by 50 mm (approx. 1-15/16 inches) (see page 55). Flat Fell Seam Use for reinforcing seams and finishing edges neatly. a Select and attach presser foot "J". a Upper thread b Bobbin thread c About 50 mm (approx. 1-15/16 inches) d Sew two rows the seam line, of straight stitches parallel then trim excess thread to leaving 50 mm (approx. 1-15/16 inches). b Sew the finish line, then cut allowance from the side on half of which the the seam flat fell seam will lie. * When the automatic thread cutting and automatic reinforcement stitching are preset, reinforcement stitches will be sewn automatically at the beginning of sewing. Press the "Reverse/Reinforcement Stitch" button to sew a reinforcement stitch and trim the thread automatically at the end of sewing. a Seam line b 10 to 15 mm (approx. 3/8 inch to 9/16 inch) c About 50 mm (approx. 1-15/16 inches) e Pull the bobbin threads to obtain the desired amount of gather, then tie the threads. a About 12 mm (approx. 1/2 inch) b Wrong side c Spread the fabric out along the finish line. f Smooth the gathers by ironing them. a Finish line b Wrong side d Lay both seam allowances on the side of the shorter seam (cut seam) and iron them. g Sew on basting the seam stitch. line and remove the 100 a Wrong side