Brother International Quattro 2 6700D Users Manual - English - Page 65

Using the Spool Stand The included spool stand is useful when using thread on spools with a large diameter (crosswound thread). This spool stand can hold two spools of thread. Memo • See page 21 to assemble the spool stand. • See page 52 to wind the bobbin when using the spool stand. UPPER THREADING • Depending on the size of spool or the amount of thread remaining, choose the appropriate sized spool cap (large or medium). Spool cap (small) cannot be used with the spool cap base. 1 Getting Ready ■ Using the Spool Stand • Be sure to use a spool cap that is slightly larger than the spool. If the spool cap that is used is smaller or much larger than the spool, the thread may catch and sewing performance may suffer. a Spool cap b Spool cap base a Attach the page 21.) spool stand to the machine. (see • When using thread on a thin spool, place the included spool felt on the spool pin, place the thread spool on the spool pin so that the center of the spool is aligned with the hole at the center of the spool felt, and then insert the spool cap onto the spool pin. b Place the spool of so that the thread thread on the spool feeds off the spool pin clockwise. Firmly insert the spool cap onto the spool pin. a Spool felt • When using thread on a cone spool, use the spool holder. a Spool holder 63