Brother International Quattro 2 6700D Users Manual - English - Page 55
Untangling Thread from Beneath the, Bobbin Winder Seat
View all Brother International Quattro 2 6700D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
■ Untangling Thread from Beneath the Bobbin Winder Seat If the bobbin winding starts when the thread is not passed through the pre-tension disk correctly, the thread may become tangled beneath the bobbin winder seat. Wind off the thread according to the following procedure. LOWER THREADING d Cut the thread near the bobbin and hold the thread end with your left hand. Unwind the thread counter clockwise near the bobbin winder seat with your right hand as shown below. 1 Getting Ready a Thread b Bobbin winder seat CAUTION • Do not remove the bobbin winder seat even if the thread becomes tangled under the bobbin winder seat. It may result in injuries. a If the thread becomes tangled under the bobbin winder seat, press once to stop the bobbin winding. e Wind the bobbin again. Note • Make sure that the thread passes through the pre-tension disk correctly (page 49). b Cut the tension thread disk. with scissors near the pre- a Pre-tension disk c Push the bobbin winder switch to the right, and then raise the bobbin at least 10 cm (4 inches) from the shaft. 53