Brother International Quattro 2 6700D Users Manual - English - Page 351

This message appears when there are not enough colors in the custom thread table, to display the color scheme you have selected to display. In this case, set more colors in the custom thread table (See page 278), or select less colors in the color shuffling function. (See page 283.) This message appears when there are not enough colors in the thread table, to display the color scheme effect you have selected. In this case, select another effect or the custom thread table (300 color palette) or less colors in the Color Shuffling function. (See page 283.) If there are not enough number of colors set in the custom thread table, set more colors in the table. (See page 278.) This message appears when 100 image files have already been saved on the USB media. In this case, delete a file from the USB media or use different USB media. (See page 39 and 87) This message is displayed when the automatic needle threading button is pushed while twin needle sewing is set. This message is displayed when the "Start/Stop" button is pressed before the edge of the fabric is detected. To detect the edge of the fabric using the built-in camera, press , raise the presser foot, and then perform the operation again. (see page 148) ERROR MESSAGES This message is displayed when the built-in camera cannot detect the edge of the fabric. If this message appeared after sewing has reached 1 to 2 cm (about 3/8 to 3/4 inch) from the edge of the fabric, refer to step m in "Edge Sewing" on page 154. If this message appeared during edge sewing, the edge of the fabric cannot be detected by the built-in camera. Press , raise the presser foot, raise the needle if it is lowered, and then perform the procedure described in "Edge Sewing" on page 150 starting from step f. If this error message appears again, sew without using edge sewing function. This message appears when you try to save more than 100 camera image or settings screen image files in the USB media. In this case, delete a file from the USB media or use different USB media. (See page 39 and 211) This message appears when or is pressed to delete the settings for a utility stitch. To delete the selected settings, press . This message is displayed when an unusable embroidery card is inserted. 9 Appendix 349