Brother International Quattro 2 6700D Users Manual - English - Page 342
Cleaning the Cutter in the Bobbin, Case Area, CAUTION
View all Brother International Quattro 2 6700D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 342 highlights
CARE AND MAINTENANCE * Make sure that the indicated points are aligned before installing the bobbin case. CAUTION • Never use a bobbin case that is scratched; otherwise, the upper thread may become tangled, the needle may break, or sewing performance may suffer. For a new bobbin case (part code: XE5342-101 (green marking on the screw), XC8167-551 (no color on the screw), XE8298-001 (gray, for bobbin work)), contact your nearest authorized dealer. • Make sure that you fit the bobbin case properly, otherwise the needle may break. i Insert the tabs on the into the needle plate, needle plate cover and then slide the cover back on. Cleaning the Cutter in the Bobbin Case Area The cutter below the needle plate should be cleaned. If dust or lint accumulate on the cutter, it will be difficult to cut the thread when the "Thread Cutter" button is pressed or the automatic thread cutting function is used. Clean the cutter when the thread is not easily cut. a Follow steps a through e in "Cleaning the Race" to remove the needle plate cover. b Use the screwdriver machine to unscrew included with the and remove the needle plate. Note • If the needle plate has been removed it is especially important to reinstall the needle plate and tighten the screws prior to installing the bobbin case. c Use the cleaning brush or a vacuum cleaner to remove any lint and dust from the cutter in the bobbin case area. a Cutter CAUTION • Do not touch the cutter, otherwise injuries may result. 340