Brother International Quattro 2 6700D Users Manual - English - Page 273

e When the . following message appears, press EDITING PATTERNS Memo • With the density scale bar, the thread den- sity can be changed. A setting between 80% and 120% in 5% increments can be specified. → The pattern will be returned to its original size, angle, and position as it was before it was edited. f Select how to change the pattern size. * Press * Press to make the pattern less dense. to make the pattern more dense. g Press . h Press . Note • Depending on the pattern, embroidering may not be possible at the appropriate thread density. Before sewing on your project, be sure to sew trial embroidery on a piece of scrap fabric that is the same as the fabric used in the project using the same needle and embroidery thread. • If the pattern is enlarged and there is space between stitches, a better effect can be achieved by increasing the thread density. • If the pattern is reduced and the stitching is too thick, a better effect can be achieved by 6 reducing the thread density. Embroidery Edit * Press * Press to enlarge the pattern proportionately. to shrink the pattern proportionately. * Press to stretch the pattern horizontally. * Press to compact the pattern horizontally. * Press to stretch the pattern vertically. * Press to compact the pattern vertically. * Press to return the pattern to its original appearance. CAUTION • Depending on the pattern, the stitching may become entangled or the needle may break when the pattern is reduced. If this occurs, enlarge the pattern slightly. 271