Brother International Quattro 2 6700D Users Manual - English - Page 215

■ Positioning the Pattern on Thick Fabric When positioning the pattern on thick fabric such as quilting, the fabric may not be detected correctly. In order for the fabric to be correctly detected, its thickness must first be measured. Memo • This feature is functional only when the fabric is scanned. It will not affect embroidering if it is turned on with normal embroidery. a Hoop the fabric in the embroidery frame, then attach the frame to the embroidery and machine. b Select the pattern, and then press . c Display page 8/8 of the Settings screen, and then set "Fabric Thickness Sensor" to "ON". d Press . e Press . f Affix the embroidery positioning sticker to the fabric within the area indicated by the red frame in the LCD, and then press . CONFIRMING THE PATTERN POSITION g When the following message appears, remove the embroidery positioning sticker, and then press . → The embroidery frame is moved, and the embroidery positioning sticker affixed to the fabric is detected. h Continue with step f on page 212 to align the pattern with the desired embroidery position. CAUTION • Use fabrics with a thickness of less than 3 mm (approx. 1/8 inch). Using fabrics thicker than 3 mm (approx. 1/8 inch) may cause the needle to break. Using the Built-In Camera to 5 Align the Embroidering Position Embroidery The embroidering position can easily be aligned using the machine's built-in camera and the included embroidery positioning sticker. Note • When embroidery frame (small) is installed, the built-in camera cannot be used to align the embroidering position. Install embroidery frame (medium) or a larger embroidery frame. a Affix the embroidery positioning the location in the fabric to be sticker to embroidered. Place the embroidery positioning sticker so that the center of the larger circle is at the center of the embroidery pattern. a Embroidery positioning sticker b Center of the embroidery pattern c Embroidery field 213