Brother International Quattro 2 6700D Users Manual - English - Page 231

ADJUSTMENTS DURING THE EMBROIDERY PROCESS ADJUSTMENTS DURING THE EMBROIDERY PROCESS Note • Be careful not to bump the embroidery unit carriage or the presser foot when removing or attaching the embroidery frame. Otherwise, the pattern will not embroider correctly. If the Bobbin Runs Out of Thread When the bobbin begins to run out of thread during embroidering, the machine will stop and the message below will appear. Press and follow the directions below to rethread the lower threading. If very little sewing remains, you can embroider 10 final stitches without rethreading the machine by pressing . The machine will stop after sewing the 10 stitches. b Unlock the frame-securing lever remove the embroidery frame. and * Be careful not to apply strong force to the fabric at this time. Otherwise, the fabric may loosen in the frame. c Insert a wound bobbin into (see page 54 for Setting the the machine. bobbin.) 5 Embroidery Note • If "Upper and Bobbin Thread Sensor" in the General settings screen of the machine setting mode is set to "OFF", the message shown above does not appear. a Press . d Press . → After the thread is automatically cut, the carriage will move. → The carriage will return to its original position. e Attach the embroidery frame. f To return to the spot in the pattern where you stopped sewing, follow steps c through i in the next section. 229