Brother International Quattro 2 6700D Users Manual - English - Page 63
Changing The Needle
View all Brother International Quattro 2 6700D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
a Press and install the twin needle ("CHANGING THE NEEDLE" on page 67). UPPER THREADING e Place the additional spool of thread on the supplemental spool pin, so that the thread unwinds from the front. Push the spool cap onto the spool pin as far as possible to secure the thread spool. 1 Getting Ready b Thread the machine for the according to the procedure first needle for threading a single needle ("Upper Threading" on page 57). a Spool cap b Spool pin c Thread spool f Hold the thread from the spool with both hands, and place the thread in the thread guide. * Do not place the thread in the pre-tension disks. c Pass the thread through the needle bar thread guides on the needle bar, then thread the needle on the left side manually. a Needle bar thread guide Note • The "Automatic Threading" button cannot be used. Manually thread the twin needle from front to back. Using the "Automatic Threading" button may result in damage to the machine. d Pull up the supplemental spool in the up position. pin and set it a Thread guide g While holding the thread from the spool, pull the thread through the lower notch in the thread guide plate, then through the upper notch. Hold the end of the thread with your left hand, and then guide the thread through the groove, following the arrows in the illustration. a Supplemental spool pin 61