Brother International Quattro 2 6700D Users Manual - English - Page 354

ERROR MESSAGES This message is displayed when the machine failed to recognize the embroidery positioning mark. - Confirm that the embroidery positioning mark is in the selected area. If problem persists, see page 215 to reposition mark. - Machine failed to recognize printed positioning mark. Set "Page Scaling" to "None (100%)", and try printing the embroidery positioning mark again. (see page 226) This message is displayed when the machine has recognized the embroidery position mark. Remove the embroidery positioning sticker and press to continue. To remove the embroidery positioning sticker more easily, press . (see page 215) This message appears when the built-in camera is being used to align the embroidery position, but the embroidery positioning sticker is too near an edge or the pattern extends from the embroidery frame. Change the positioning of the embroidery position sticker, and then try aligning the position again. See page 208. This message is displayed when the upper thread is broken or not threaded correctly, and the "Start/Stop" button or the "Reverse/ Reinforcement Stitch" button is pressed. This message is displayed when the "Presser Foot Lifter" button is pushed while the presser foot lever is raised/ the needle is lowered. 352 This message is displayed when the "Start/Stop" button is pushed to sew Utility stitches or Character/ Decorative stitches while the foot controller is connected. (This message does not appear when embroidering). This message is displayed when the "Start/ Stop" button is pushed while the machine is in embroidery edit mode and a pattern is being edited. This message is displayed when there is no stitch or embroidery pattern selected and the "Start/Stop" button or the "Reverse/Reinforcement Stitch" button is pressed. This message is displayed when the bobbin thread is running out. This message is displayed when the memory is full and the stitch or pattern cannot be saved.