Brother International Quattro 2 6700D Users Manual - English - Page 237
Using the Automatic Thread, Cutting Function, END COLOR TRIM, CAUTION
View all Brother International Quattro 2 6700D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 237 highlights
■ Bobbin Thread is Too Loose Bobbin thread appears slightly on the right side of fabric. MAKING EMBROIDERY ADJUSTMENTS Using the Automatic Thread Cutting Function (END COLOR TRIM) a Right side b Wrong side If this occurs, turn the slotted screw (-) clockwise, being careful not to over-tighten the screw, approximately 30-45 degrees to increase bobbin tension. The automatic thread cutting function will cut the thread at the end of sewing each color. This function is initially turned on. To turn this function off, press key and then . This function can be turned on or off during embroidering. * This setting returns to its default when the machine is turned off. a Press . ■ Bobbin Thread is Too Tight Upper thread on the right side of fabric seems to be lifting/looping and bobbin thread is not seen on the wrong side of fabric. 5 a Right side b Wrong side If this occurs, turn the slotted screw (-) counterclockwise, being careful not to over-loosen the screw, approximately 30-45 degrees to decrease bobbin tension. Embroidery CAUTION • When adjusting the alternate bobbin case, be sure to remove the bobbin from the alternate bobbin case. • DO NOT adjust the position of the phillips (+) screw on the alternate bobbin case as this may result in damage to the bobbin case, rendering it unusable. • If the slotted screw (-) is difficult to turn, do not use force. Turning the screw too much or providing force in either (rotational) direction may cause damage to the bobbin case. Should damage occur, the bobbin case may not maintain proper tension. b Press to turn off the automatic thread cutting function. → The key will display as * When one color thread is sewn, the machine will stop without cutting the thread. 235