Brother International Quattro 2 6700D Users Manual - English - Page 57

LOWER THREADING g Pass the thread through the guide, and pull the thread out toward the front. then Pulling Up the Bobbin Thread There may be some sewing applications where you want to pull up the bobbin thread; for 1 example, when making gathers, darts, or doing free motion quilting or embroidery. Getting Ready a Cutter → The cutter cuts the thread. Note • If the thread is not correctly inserted through the tension spring of the bobbin case, it may cause incorrect thread tension. (see page 79) Memo • You can pull up the bobbin thread after threading the upper thread ("UPPER THREADING" on page 57). a Guide the bobbin groove, following thread through the the arrow in the illustration. * Do not cut the thread with the cutter. * Do not replace the bobbin cover. b While holding the "Needle Position" upper thread, press the button to lower the needle. a Tension spring CAUTION • Be sure to hold down the bobbin with your finger and unwind the bobbin thread correctly. Otherwise, the thread may break or the thread tension will be incorrect. h Insert the tab bobbin cover in the lower-left corner of (1), and then lightly press the down on the right side to close the cover (2). a "Needle Position" button c Press the "Needle the needle. Position" button to raise d Gently pull the upper thread. A loop of the bobbin thread will come out of the hole in the needle plate. 55