Brother International Quattro 2 6700D Users Manual - English - Page 23
Using the Spool Stand, CAUTION
View all Brother International Quattro 2 6700D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
NAMES OF MACHINE PARTS AND THEIR FUNCTIONS Note • Embroidery cards purchased in foreign countries may not work with your machine. • Visit your nearest authorized Brother dealer for a complete listing of optional accessories and embroidery cards available for your machine. ■ How to assemble the spool stand a Fully extend the telescopic thread guide shaft, and then rotate the shaft until the two internal stoppers click into place. Using the Spool Stand The included spool stand is useful when using thread spools with a large diameter (cross-wound thread). The spool stand can hold two spools of thread. 1 2 3 b Insert the telescopic thread guide into round hole at the center of the spool the support, and then use a screwdriver to securely tighten the screw (a) from the reverse side. 4 5 6 7 8 No. Part Name 1 Telescopic thread guide 2 Spool support 3 Spool pin × 2 4 Screw and washer 5 Spool cap (XL) × 2 6 Spool holder × 2 7 Spool cap base × 2 8 Spool felt × 2 Part Code XE0776-001 XE4637-001 XA6313-051 XC7568-051 XE0779-001 XA0679-050 XE0780-001 XC7134-051 CAUTION • Do not lift the handle of the machine while the spool stand is installed. • Do not push or pull the telescopic thread guide or spool pins with extreme force, otherwise damage may result. • Do not place any object other than spools of thread on the spool support. • Do not try to wind thread on the bobbin while sewing using the spool stand. a Screw Note • Make sure that the stoppers on the tele- scopic thread guide shaft are firmly in place and that the top of the thread guide is directly above the spool pins. In addition, check that the shaft is securely tightened in the spool support. 21