Brother International Quattro 2 6700D Users Manual - English - Page 62
Using the Twin Needle Mode, CAUTION
View all Brother International Quattro 2 6700D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
UPPER THREADING n Carefully pull the end of the thread that passed through the eye of the needle. was * If a loop was formed in the thread passed through the eye of the needle, carefully pull on the loop of thread through to the back of the needle. Note • Some needles cannot be threaded with the needle threader. In this case, instead of using the needle threader after passing the thread through the needle bar thread guide (marked "6"), manually pass the thread through the eye of the needle from the front. Note • Pulling the loop of thread gently will avoid needle breakage. o Pull out about 10-15 cm (approx. 4-6 inches) of the thread, and then pass it under the presser foot toward the rear of the machine. → Raise the presser foot lever if the presser foot is lowered. Using the Twin Needle Mode The twin needle can only be used for patterns that show after being selected. Before you select a stitch pattern, make sure the stitch can be sewn in the twin needle mode (refer to the "STITCH SETTING CHART" at the end of this manual). a About 10-15 cm (approx. 4-6 inches) Memo • If the needle could not be threaded or the thread was not passed through the needle bar thread guides, perform the procedure again starting from step c. Then, pass the thread through the eye of the needle after step i. CAUTION • Twin needle (part code XE4963-001) is recommended for this machine. Contact your authorized dealer for replacement needles (size 2.0/11 is recommended). • Be sure to set the twin needle mode when using the twin needle. Using the twin needle while the machine is in single needle mode could cause the needle to break, resulting in damage. • Do not sew with bent needles. The needle could break and cause injury. • When using the twin needle, it is recommended to use presser foot "J". • When the twin needle is used, bunched stitches may occur depending on the types of fabric and thread that are used. Use monogramming foot "N" for decorative stitches. • Before changing the needle or threading the machine, be sure to press on the LCD Screen, otherwise injuries may occur if the "Start/Stop" button or any other button is pressed and the machine starts sewing. 60