Brother International Quattro 2 6700D Users Manual - English - Page 315

m Gently pull the upper thread to bring the bobbin thread up through the needle plate. PREPARING FOR BOBBIN WORK Note • When installing the needle plate cover, do not allow it to pinch the thread. q Install the flat bed embroidery unit. attachment or → A loop of the bobbin thread comes out through the hole in the needle plate. n Insert tweezers through bobbin thread loop and pull bobbin thread above the needle plate. o Align the upper thread and bobbin thread, and then pull out about 10 cm (approx. 4 inches) of the threads and pass them under the presser foot toward the rear of the machine. Note • When installing the flat bed attachment or embroidery unit, do not allow it to pinch the thread. • When the bobbin thread is replaced with a new one, be sure to repeat the procedure from a, otherwise the lower threading will not be done correctly. → This completes the upper and lower threading. Note • If utility stitches are to be used, refer to "CREATING BOBBIN WORK (SEWING)" on page 314. If embroidery patterns are to be used, refer to "CREATING BOBBIN WORK (EMBROIDERY)" on page 318. p Install the needle cover with tabs. plate cover and bobbin For details on installing the needle plate cover, refer to "Cleaning the Race" on page 338. 7 How to Create Bobbin Work a Bobbin cover b Bobbin cover with tabs CAUTION • When creating bobbin work, use the bobbin cover with tabs, otherwise the thread may become tangled or the needle may break. 313