Cisco 7920 Administration Guide - Page 53

Chapter 2 An Overview of the Wireless Network Wireless Network and Access Point Configuration Table 2-3 DHCP Settings Priority Priority 1st 2nd 3rd 4th DHCP Settings DHCP option 150 DHCP option 66 SIADDR ciscoCM1 If DHCP is disabled, the Cisco Wireless IP Phone 7920 uses the following network settings to perform the phone provisioning bootup process. You must configure these static parameters for each Cisco Wireless IP Phone 7920. • Primary TFTP server IP • Primary DNS server IP • Secondary DNS server IP • IP address • Subnet mask IP • Primary gateway IP Wireless Network and Access Point Configuration This section identifies key access point (AP) configuration options that are required for optimal voice performance. This is not a complete list of configuration steps or options for installing access points such as the Cisco Aironet Access Points. For more information about configuring your access point, refer to the appropriate installation and configuration guide for your model or the documentation for your access point. When configuring a wireless voice LAN, use access points that run Cisco IOS Version 12.2(15)JA or later. The access points that run IOS include the following: • Cisco Aironet Access Point 350 series • Cisco Aironet Access Point 1100 series • Cisco Aironet Access Point 1200 series OL-7104-01 Cisco Wireless IP Phone 7920 Administration Guide for Cisco CallManager Release 4.0 and 4.1 2-19