Cisco 7920 Administration Guide - Page 71

Chapter 3 Setting Up Cisco Wireless IP Phones Configuring IP Phones in Cisco CallManager Related Topics • Support for the Cisco 7920 Phone Type, page 3-11 • Adding Phones with Auto-Registration, page 3-8 • Adding Phones with Auto-Registration and TAPS, page 3-9 • Adding Phones with Cisco CallManager Administration, page 3-11 Adding Phones with Cisco CallManager Administration You can add phones individually to the Cisco CallManager database using Cisco CallManager Administration. To do so, you first must obtain the MAC address for each phone. See the "Adding Phones to the Cisco CallManager Database" section on page 3-7 for instructions. After you have collected MAC addresses, choose Device > Add a New Device in Cisco CallManager Administration to begin. For additional instructions and conceptual information about Cisco CallManager, refer to Cisco CallManager Administration Guide and to Cisco CallManager System Guide. Related Topics • Support for the Cisco 7920 Phone Type, page 3-11 • Adding Phones with Auto-Registration, page 3-8 • Adding Phones with Auto-Registration and TAPS, page 3-9 • Adding Phones with BAT, page 3-10 Support for the Cisco 7920 Phone Type Cisco CallManager release 3.3(3) SR1 and later includes support for the Cisco 7920 phone type in the Cisco CallManager Administration application. (Previously, there was no phone type for this phone and you had to configure it as a Cisco IP Phone 7960.) If you upgrade to Cisco CallManager release 3.3(3) SR1 and later, you can choose the Cisco 7920 phone type when adding the wireless phone. However, if you perform the upgrade and have Cisco wireless phones on your network that were OL-7104-01 Cisco Wireless IP Phone 7920 Administration Guide for Cisco CallManager Release 4.0 and 4.1 3-11