Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 1025
stack-unit priority, stack-unit, priority, provision, S25N | 25P, S25V | S50N, S50V | S55
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1025 highlights
Related Commands reset stack-unit show hardware stack-unit show system (S-Series) upgrade (S-Series management unit) Reset the designated S-Series stack member. Display the data plane or management plane input and output statistics of the designated component of the designated stack member. Display the current status of all stack members or a specific member. Upgrade the bootflash image or system image of the S-Series management unit. stack-unit priority s Configure the ability of an S-Series switch to become the management unit of a stack. Syntax stack-unit stack-unit priority preference Parameters stack-unit preference Enter the stack member unit identifier of the stack member to reset. S55 range: 0 - 11 This preference parameter allows you to specify the management priority of one backup switch over another, Range 1-14, with 1 the lowest priority and 14 the highest. The switch with the highest priority value will be chosen to become the management unit if the active management unit fails or on the next reload. Defaults 1 Command Modes CONFIGURATION Command History Version 8.3.5.1 Version 7.7.1.0 Introduced on S55 Introduced on S-Series Related Commands reload show system (S-Series) Reboot FTOS. Display the current status of all stack members or a specific member. stack-unit provision s Pre-configure a logical stacking ID of a switch that will join the stack. This is an optional command that is executed on the management unit. Syntax stack-unit stack-unit provision {S25N | 25P | S25V | S50N | S50V | S55} Parameters stack-unit S25N|S25P|S25V|| S50N|S50V|S55 Enter the stack member unit identifier of the stack member to reset. S55 range: 0 - 11 Enter the S-Series model identifier of the switch to be added as a stack member. This identifier is also referred to as the provision type. Note: The S55 does not support stacking with any other platform Defaults When this value is not set, a switch joining the stack is given the next available sequential stack member identifier. S-Series Stacking Commands | 1025