Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 60

www.dell.com | support.dell.com Example Command example: upgrade fpga-image Force10#conf Force10(conf)# upgrade primary-fpga-flash rpm Proceed to upgrade primary fpga flash for rpm 0 [confirm yes/no]: yes Force10# Usage Information Related Commands Reset the card using the power-cycle option after restoring the FPGA command. reset restore fpga-image Reset a line card or RPM. This command copies the backup FPGA image to the primary FPGA image. upgrade fpga-image (S55) Upgrade the FPGA version on the S55. Syntax Parameters upgrade fpga-image stack-unit {0-11} booted stack-unit booted Enter the keyword stack-unit to upgrade the FPGA on the specified S55 chassis. Upgrade the FPGA image using the currently running FTOS image. Defaults Command Modes Command History Example No default values or behavior EXEC Privilege Version 8.3.5.0 Introduced on the S55 Command example: upgrade fpga-image Force10#upgrade fpga-image stack-unit 0 booted Current FPGA information in the system Card FPGA Name Current Version New Version Unit0 S55 SYSTEM FPGA 15 16 * Warning - Upgrading FPGA is inherently risky and should * * only be attempted when necessary. A failure at this upgrade may * * cause a board RMA. Proceed with caution ! * Upgrade fpga image for stack-unit 0 [yes/no]: yes FPGA upgrade in progress. Please do NOT power off the card Upgrade result Unit 0 FPGA upgrade successful. Power cycle the stack-unit to complete the upgrade. Force10# 60 | File Management