Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 521
ip address, range
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 521 highlights
Usage Information Example Use the count option to stop packets from flooding the user terminal when debugging is turned on. The access-group option supports only the equal to (eq) operator in TCP ACL rules. Port operators not equal to (neq), greater than (gt), less than (lt), or range are not supported in access-group option (see Figure 16-4). ARP packets (arp) and Ether-type (ether-type) are also not supported in access-group option. The entire rule is skipped to compose the filter. The access-group option pertains to: • IP Protocol Number • Internet Control Message Protocol* * but not the ICMP message type (0-255) • Any Internet Protocol • Transmission Control Protocol* * but not on the rst, syn, or urg bit • User Datagram Protocol 0 to 255 icmp ip tcp udp In the case of ambiguous access control list rules, the debug ip packet access-control command will be disabled. A message appears identifying the error (see Figure 16-4). Figure 16-4. debug ip packet access-group Command Errors Force10#debug ip packet access-group test %Error: port operator GT not supported in access-list debug %Error: port operator LT not supported in access-list debug %Error: port operator RANGE not supported in access-list debug %Error: port operator NEQ not supported in access-list debug Force10#00:10:45: %RPM0-P:CP %IPMGR-3-DEBUG_IP_PACKET_ACL_AMBIGUOUS_EXP: Ambiguous rules not supported in access-list debug, access-list debugging is turned off Force10# ip address c e s Assign a primary and secondary IP address to the interface. Syntax ip address ip-address mask [secondary] To delete an IP address from an interface, use the no ip address [ip-address] command. Parameters ip-address mask secondary Enter an IP address in dotted decimal format. Enter the mask of the IP address in slash prefix format (for example, /24). (OPTIONAL) Enter the keyword secondary to designate the IP address as the secondary address. Defaults Not configured. Command Modes INTERFACE Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Introduced on the S55. Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series IPv4 Routing | 521