Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 1074
virtual-address
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1074 highlights
www.dell.com | support.dell.com Parameters interface cost Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Loopback interface, enter the keyword loopback followed by a number from 0 to 16383. • For Port Channel interface types, enter the keyword port-channel followed by the number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 255 for TeraScale • For SONET interfaces, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. (OPTIONAL) Enter a number as the amount to be subtracted from the priority value. Range: 1 to 254. Default: 10. Defaults cost = 10 Command Modes VRRP Command History Version 8.3.5.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage If the interface is disabled, the cost value is subtracted from the priority value and forces a new Information MASTER election if the priority value is lower than the priority value in the BACKUP virtual routers. virtual-address c e s Configure up to 12 IP addresses of virtual routers in the VRRP group. You must set at least one virtual address for the VRRP group to start sending VRRP packets. Syntax virtual-address ip-address1 [... ip-address12] To delete one or more virtual IP addresses, use the no virtual-address ip-address1 [... ip-address12] command. Parameters ip-address1 ... ip-address12 Enter an IP address of the virtual router in dotted decimal format. The IP address must be on the same subnet as the interface's primary IP address. (OPTIONAL) Enter up 11 additional IP addresses of virtual routers in dotted decimal format. Separate the IP addresses with a space. The IP addresses must be on the same subnet as the interface's primary IP address. Defaults Not configured. Command Modes VRRP 1074 | Virtual Router Redundancy Protocol (VRRP)