Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 971

Usage Information Related Commands The polling interval for an interface is the maximum number of seconds between successive samples of counters to be sent to the collector. This command changes the global default counter polling (20 seconds) interval. You can configure an interface to use a different polling interval. sflow polling-interval (Interface) Set the polling interval for an interface sflow polling-interval (Interface) c e s Set the sFlow polling interval at an interface (overrides the global-level setting.) Syntax sflow polling-interval interval value To return to the default, use the no sflow polling-interval interval command. Parameters interval value Enter the interval value in seconds. Range: 15 to 86400 seconds Default: The global counter polling interval Defaults The same value as the current global default counter polling interval Command Modes INTERFACE Command History Version 8.3.5.0 Version 8.2.1.0 Version 8.1.1.0 Version 7.7.1.0 Version 7.6.1.0 Version 6.2.1.1 Introduced on S55 Introduces on S-Series Stacking Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage This command sets the counter polling interval for an interface. Information Related Commands sflow polling-interval (Global) Globally set the polling interval sflow sample-rate (Global) c e s Change the global default sampling rate. Syntax Parameters sflow sample-rate value To return to the default sampling rate, enter the no sflow sample-rate. value Enter the sampling rate value. Range: C-Series and S-Series: 256 to 8388608 packets E-Series TeraScale and ExaScale: 2 to 8388608 Enter values in powers of 2 only, for example 4096, 8192, 16384 etc. Default: 32768 packets sFlow | 971