Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 28
boot network, boot system C-Series and E-Series
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
www.dell.com | support.dell.com Usage Information Related Commands To display these changes in the show bootvar command output, you must save the running configuration to the startup configuration (using the copy command). show bootvar Display the variable settings for the E-Series boot parameters. boot network c e Set the location of the configuration file in a remote network. Syntax boot network {primary | secondary} remote-url To return to the default settings, enter no boot network {primary | secondary} command. Parameters primary secondary remote-url Enter the keywords primary to attempt to load the primary network configuration files. Enter the keywords secondary to attempt to load the secondary network configuration files. Enter the following location keywords and information: • For a file on an FTP server, enter ftp://user:password@hostip/filepath • For a file on a TFTP server, enter tftp://hostip/filepath Defaults None Command Modes CONFIGURATION Command History Version 7.5.1.0 Introduced on C-Series E-Series original Command Usage To display these changes in the show bootvar command output, you must save the running Information configuration to the startup configuration (using the copy command). Related Commands show bootvar Display the variable settings for the E-Series boot parameters. boot system (C-Series and E-Series) c e Tell the system where to access the FTOS image used to boot the system. Syntax boot system {rpm0 | rpm1} (default | primary | secondary} file-url To return to the default boot sequence, use the no boot system {rpm0 | rpm1} {primary | secondary} command. Parameters rpm0 rpm1 default Enter the keyword rpm0 to configure boot parameters for RPM0. Enter the keyword rpm1 to configure boot parameters for RPM1. After entering rpm0 or rpm1, enter the keyword default to specify the parameters to be used if those specified by primary or secondary fail. The default location should always be the internal flash device (flash:), so that you can be sure that a verified image is available there. 28 | File Management