Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 813
show interfaces rate
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 813 highlights
Table 32-1. Default dot1p to Queue Mapping (continued) dot1p 3 4 5 6 7 E-Series Queue ID 3 4 5 6 7 C-Series Queue ID 1 2 2 3 3 S-Series Queue ID 1 2 2 3 3 Command Modes INTERFACE CONFIGURATION (C-Series and S-Series only) Command History Version 8.3.5.0 Version 8.2.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.5.1.0 pre-Version 6.1.1.1 Introduced on S55 Available globally on the C-Series and S-Series so that the configuration applies to all ports. Introduced on S-Series Introduced on C-Series Expanded command to permit configuration on port channels Introduced on E-Series Usage Information Enter this command to honor all incoming 802.1p markings, on incoming switched traffic, on the interface. By default, this facility is not enabled (that is, the 802.1p markings on incoming traffic are not honored). This command can be applied on both physical interfaces and port channels. When you set the service-class dynamic for a port channel, the physical interfaces assigned to the port channel are automatically configured; you cannot assign the service-class dynamic command to individual interfaces in a port channel. On the C-Series and S-Series all traffic is by default mapped to the same queue, Queue 0. If you honor dot1p on ingress, then you can create service classes based the queueing strategy using the command service-class dynamic dot1p from INTERFACE mode. You may apply this queuing strategy to all interfaces by entering this command from CONFIGURATION mode. • All dot1p traffic is mapped to Queue 0 unless service-class dynamic dot1p is enabled on an interface or globally. • Layer 2 or Layer 3 service policies supercede dot1p service classes. show interfaces rate e Display information of either rate limiting or rate policing on the interface. Syntax show interfaces [interface] rate [limit | police] Quality of Service (QoS) | 813