Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 89
reload, reset
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Related Commands power-off Power off a line card or standby SFM. reload c e s Reboot FTOS. Syntax reload Command Modes EXEC Privilege Command History Version 8.3.5.0 Introduced on the S55. Version 7.6.1.0 Introduced on S-Series Version 7.5.1.0 Introduced on C-Series E-Series original Command Usage If there is a change in the configuration, FTOS will prompt you to save the new configuration. Or you Information can save your running configuration with the copy running-config command. Refer to Chapter 9, Bare Metal Provisioning for information related to the BMP reload options. Related Commands reset reset stack-unit reload-type Reset a line card, RPM, or a failed SFM (TeraScale and ExaScale). Reset any designated stack member except the management unit Configure a switch to reload in normal mode or as a DHCP client with all ports configured for Layer 3 traffic. reset c e Reset a line card, RPM, or a failed SFM (TeraScale only). Syntax reset {linecard number [hard | power-cycle] | rpm number [hard | power-cycle ] | sfm slot number} Parameters linecard number hard power-cycle Enter the keyword linecard and a number for the line card slot number. (Optional) Add the keyword hard or power-cycle (power-cycle is C-Series only) to power cycle the line card. C-Series Range: 0-7 E-Series Range: 0 to 13 on E1200/E1200i, 0 to 6 on E600/E600i, and 0 to 5 on E300 Enter the keyword hard to power cycle the line card. Enter the keyword power-cycle after upgrading a C-Series FPGA to cause the FPGA to be reprogrammed based on the contents of the FPGA PROM. Note: This option is supported on C-Series only. Control and Monitoring | 89