Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 181

Version 7.5.1.0 pre-Version 6.2.1.1 Support added for C-Series Introduced Example Figure 7-3. Command Example: show ip accounting access-lists Force10#show ip accounting access FILTER1 interface gig 1/6 Extended IP access list FILTER1 seq 5 deny ip any 191.1.0.0 /16 count (0x00 packets) seq 10 deny ip any 191.2.0.0 /16 order 4 seq 15 deny ip any 191.3.0.0 /16 seq 20 deny ip any 191.4.0.0 /16 seq 25 deny ip any 191.5.0.0 /16 Table 7-1 defines the information in Figure 7-3. Table 7-1. show ip accounting access-lists Command Example Field Field "Extended IP ..." "seq 5 ..." "order 4" Description Displays the name of the IP ACL. Displays the filter. If the keywords count or byte were configured in the filter, the number of packets or bytes processed by the filter is displayed at the end of the line. Displays the QoS order of priority for the ACL entry. Standard IP ACL Commands When an ACL is created without any rule and then applied to an interface, ACL behavior reflects an implicit permit. c and s platforms (except the S55) support Ingress IP ACLs only. The supports both Ingress and Egress IP ACLs. The commands needed to configure a Standard IP ACL are: • deny • ip access-list standard • permit • resequence access-list • resequence prefix-list ipv4 • seq Note: See also Commands Common to all ACL Types and Common IP ACL Commands. Access Control Lists (ACL) | 181